Cino Fuzzyscan MBC6890 series Guía de usuario descargar pdf (Pagina 15)

MBC6890 User’s Guide

Enable Out-of-Range Scanning

Under normal mode (default setting), when the radio link between the

MBC6890 and the host system is built, the MBC6890 transmits each

scanned data right after scanning the bar code label. However, the

MBC6890 can not scan any bar code data while losing its connection

with the remote host system due to out of range. You might enable the

option of “Out-of-range Scanning” to have MBC6890 stored the

scanned data even the imager is out of range. To enable this function,

please refer and follow the programming procedures.

When the MBC6890 is out of range, you will hear 4 beeps in

descending tone to indicate the radio connection lost. Then, the

MBC6890 gives red blinks at regular interval. You still can scan the bar

code even the radio connection has been discontinued. When a bar

code is saved successfully, a good read beep sounds and the LED

flashes green. When the memory buffer is full, the MBC6890 will give a

long beep and the LED flashes red.

When the MBC6890 enters into the working range, the data

transmission is triggered right after the radio link is rebuilt automatically.

You will hear 4 beeps in ascending tone to indicate the radio link built.

Following two short beeps, the MBC6890 gives continuous short clicks

and red blinks during the transmission process. After data transmission

is completed, the imager indicates four short beeps.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 53 54

Sin comentarios

Cino Fuzzyscan MBC6890 series Guía de usuario Pagina 15