Cino Fuzzyscan MBC6890 series Guía de usuario descargar pdf (Pagina 12)

The Installation Procedure

Please refer to following procedures for connecting MBC6890 to a host

system by using with DB100 smart cradle:

(1) Make sure that batteries are fully charged and placed into

MBC6890. You may refer to the Section “Preparations Before

Using” for details.

(2) Power off the host system.

(3) Connect the desired interface cable (such as: PS/2 keyboard

wedge interface cable) with DB100 smart cradle and host PC.

You will hear a ‘click’ when the connection is made.

(4) Plug the power supply unit into an AC outlet.

(5) Plug the DC plug of power supply unit into the DB100 smart

cradle. The radio link condition between imager and cradle will

be presented by the status LED of cradle. Please refer to

Section “DB100 Smart Cradle Indications” for details.

(6) Power on the host system.

(7) Check that MBC6890 gives alternating red-green blinks, means

it is in “Uninstall” state. If the imager has been in “Uninstall”

state already, the next step can be skipped.

(8) Scan the “Uninstall” barcode command. The imager gives 4

short beeps. Then imager LED gives alternating red-green

blinks.

Uninstall Command

The imager will automatically switch to “Sleep State” in 30

seconds, if there’s no further operation under “Uninstall State”.

Press the imager trigger switch to wake up the imager from the

“Sleep State”.

MBC6890 User’s Guide

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 53 54

Sin comentarios

Cino Fuzzyscan MBC6890 series Guía de usuario Pagina 12